The NEXUS-RELAY, DIM-LE and DIM-TE modules can use momentary or toggle switching. You can change the set state of the device in two ways, manually or using a parameter in the software.
If you attempt to turn the light on manually using the bell press push button mech and the light switches off on release, this will indicate the the device is in toggle and will need to be changed to momentary.
NOTE A MOMENTARY MECH MUST BE USED FOR MANUAL DIMMING CONTROL AS WELL AS TWO WAY SWITCHING
Change the state of the device manually:
To manually change the state of the device simply press and hold the "sync button" on the back of the device for approximately 6 seconds. The LED will flash rapidly to indicate the change.
Change the state of the device through the software:
1. Log into the NEXUS-BRIDGE at login.environexus.com.au
2. Select the spanner on the device
3. Select the "Device Option" tab, and click "Add Configuration Settings"
Insert the below values:
Data Size: 1 byte dec (1d)
Desired Value: 0 (momentary switch)
1 (toggle switch)
NOTE: The Default value for all devices is 1 (toggle switch)
4. Close the screen and click Save