IMPORTANT : A licensed NEXUS Certified Electrician with knowledge and understanding of electrical systems and electrical safety should complete the electrical installation.
STEP 1: TURN OFF ELECTRICITY
The electricity to the circuit must be shut off during installation for safety and to ensure that wires are not short-circuited which will cause damage to the NEXUS-BLIND.
STEP 2: WIRE THE NEXUS-BLIND
The NEXUS-BLIND must first be powered by a 3-wire system in order to operate. The wiring diagram is as follows:
STEP 3: CHANGE THE STATE OF THE DEVICE (If Required)
As a factory default, your new NEXUS-BLIND will be set for toggle mode,
To change this state, press and hold the SYNC BUTTON for 8-10 seconds, until the LED begins to flash rapidly.