Nero Relay
The Nero Relay switches on and off an electrical load up to 10A.
The module can be controlled either through a Z-Wave Controller or through a wall switch.
The module measures the power consumption of the attached load and supports connection of a digital temperature sensor (available separately).
Nero Relay operates as a repeater in your mesh network, increasing reliability and range when combined with other Nero devices.
Installation
RISK OF ELECTRICAL SHOCK! This device should only be installed by a qualified electrician and with appropriate precautions taken to ensure that power is not present during installation.
Even when the module is turned off, voltage may be present on its terminals. Any works on changes related to connection mode or load must always be performed with power disconnected.
- Before the installation, disconnect the power supply
- Connect the module according to electrical diagram
- Locate the antenna as far as possible from metal elements
- Do not shorten the antenna
- Nero Relay requires an active and neutral for operation
Supported Switches
The module supports momentary switches (push button) and toggle switches. The module is factory set to operate with momentary switches. Momentary switches are recommended.
Overcurrent Protection Fuse
Nero Relay must be installed with an over-current protection fuse not rated higher than 10A as illustrated in the wiring diagram.
Wiring Diagrams
High Voltage (AC)
Terminal | 230V AC |
N | Neutral |
L | Live/Active |
OUT | Load |
I3 | Not in use |
I2 | Not in use |
I1 | Input wall switch |
TS | Temperature sensor connection |
Low Voltage (DC)
Terminal | 24V DC |
N | Positive |
L | Negative |
OUT | Load |
I3 | Not in use |
I2 | Not in use |
I1 | Input wall switch |
TS | Temperature sensor connection |
Specifications
Power Supply | 110-230V AC ±10% @ 50Hz (24-30V DC) |
Maximum load (resistive) | 10A (2300W @ 230V AC) 10A (240W @ 24V DC) |
Maximum load (capacitive) | 320W @ 230V AC |
Maximum load (electric motor) | 690W @ 230V AC (power factor 0.4) |
Power measurement accuracy | 5-50W: ±3W >50W: ±3% |
Temperature sensor range | -50 to +125ºC |
Operating temperature | -10 to +40ºC |
Wireless mesh range | Up to 30m indoors |
Own electrical consumption | 0.4W |